Flower Lace Happy Birthday by Louise Healy

INSTRUCTIONS

  1. Fold a 6" x 9-1/2" piece of blue cardstock in half to form an A6 card.
  2. Die cut a white and yellow layer from the Fitted Frames set A size V.
  3. Tape the Happy Birthday stencil to the white die cut frame with removable tape.
  4. Use a 1/4" stencil brush to rouge a coat of VersaMark over the whole design, remove the stencil, sprinkle the image with Clear Turquoise Embossing Powder, tap off extra, heat set, adhere to the matching yellow mat.
  5. Place the Flower Lace stencil face down on a clean paper towel and pat the back of the stencil with the Neon Yellow ink pad until the whole back is covered.
  6. Carefully place the stencil ink side up on the platform of a die cut machine, place a 4-1/4" x 5-1/2" piece of white cardstock on the stencil, cover with a rubber embossing mat and two cutting mats, run through the machine, let dry.
  7. Trim the Letterpressed piece to 4" x 4-3/4" and adhere the piece to the front of the card.
  8. Wrap a piece of yellow ribbon around the card front and adhere near the right side with Craft Glue Dots, make a small matching bow and attach near the left with a Craft Glue Dot.
  9. Use foam tape to add the embossed saying to the card.
Print Project

Also uses these supplies:

  • Cardstock by My Mind's Eye
  • Radiant Neon™ Electric Yellow Ink by Tsukineko®
  • Ribbon by May Arts
  • Glue Dots® Foam Mounting Tape by 3M®
  • 1/2" Removable Tape by 3M®
  • Rubber Embossing Mat Paper Towel

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project