Hydrangea Metal Stencil by Pam Hornschu

INSTRUCTIONS

  1. Create 4 1/2 X 6 inch side-fold card from aqua cardstock.
  2. Ink-stencil with Teal ink through Flower Lace stencil using a large stencil brush over card front.
  3. Rub Memento colors over glossy cardstock panel, concentrating loosely on where flowers will end up and where leaves will be.
  4. Place hydrangea stencil over surface, and tape down with removable tape on all four sides. Spread Translucent paste over design using palette knife and spreader. Remove stencil to clean immediately, and set panel aside to dry thoroughly (overnight is best).
  5.  Replace clean stencil over top of pasted design. *Use barely damp baby wipes and/or damp paper towels to remove black ink from design areas. You can also use a small amount of rubbing alcohol on a cotton swab to get in more detailed areas, but be careful not to use too much as it can leave the surface sticky.
  6. Adhere panel to card front. Punch one hole on folded edge, and insert and wrap ribbon around to front, and tie bow.
Print Project

Also uses these supplies:

Stampendous: MPW811 Mixed Media White Paper
Dreamweaver: DWLJ888 Hydrangea Stencil
LJ820 Flower Lace Stencil
DWDEPT Translucent Embossing Paste
DWNHB-18 Natural Handle 3/4" Stencil Brush
DWLM2010 Paste Spreader
DWDPK Palette Knife
Plus: Memento™
Lulu Lavender, Grape Jelly, Rose Bud, Bahama Blue, Pear Tart, Bamboo Leaves, and Teal Zeal Inks by Tsukineko®
StazOn™ Black Ink by Tsukineko®
Aqua Cardstock by Bazzill Basics Paper® Glossy White Cardstock Zip Dry™
Paper Glue by Beacon Adhesives
Silk Ribbon by May Arts
Cotton swabs, Isopropyl (rubbing) Alcohol Baby Wipes or Paper towels
1/4" Hole Punch

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project