Rooster Fleur De Lis by Laura Drahozal

INSTRUCTIONS
  1. Fold a piece of 5 1/2” by  8 1/2 ” card stock so that the fold is on the side.
  2. Place the rooster stencil on top of the base of your die cut machine facing up.
  3. Place the copper coated aluminum face up on top of the stencil.
  4. Cover with the Stamping Details Rubber Mat and then the cutting mats for your machine.
  5. Run the project through the machine. 
  6. With the stencil still in place, sand the image.
  7. Cut around the image, leaving just a little silvery color around the image.
  8. Place the Fleur De Lis stencil face down on the base of your die cut machine.
  9. Place the black coated aluminum face down on top of the stencil.
  10. Cover with the rubber mat and the cutting mats for your machine.
  11. Run the project through the machine.
  12. Remove the stencil and lightly sand on the top of the image.
  13. Trim the metal close to the image.
  14. Assemble the card, gluing with the Zip-Dry and being patient until it dries.
Print Project

Also uses these supplies:

  • My Colors Cardstock by My Mind's Eye (Caribbean Sea)
  • Colored Aluminum by Mercart (Copper, Black)
  • Sandpaper or Sanding Block
  • Scissors
  • Big Shot™ by Sizzix®
  • Rubber Mat
  • Zip-Dry™ Paper Glue by Beacon Adhesives

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project