Poinsettia Pattern by Alison Heikkila

INSTRUCTIONS
  1. Tape the Poinsettia Pattern Stencil to a piece of Mixed Media White Paper.
  2. On a Craft Mat, scoop out a small amount Glossy White Embossing Paste and 1-2 drops of Cadmium Red Hue.
  3. Using the Palette Knife, mix the paste and paint together, but not completely. Leave it marbleized. 
  4. Apply the tinted paste to the stencil and paper by spreading it across the top at a 45 degree angle with the Paste Spreader.
  5. Remove and clean the stencil. Let paste dry and trim the image, leaving a border.
  6. Create the card base out of Evergreen cardstock, cut to the size of 6-1/2" x 10." 
  7. Using a scrap piece of Evergreen cardstock, stamp the Christmas sentiment on the BACK of the textured cardstock using VersaMark ink.
  8. Sprinkle on Detail White Embossing Powder and heat set. 
  9. Using the Large "H" Fitted Frame, die cut the sentiment. 
  10. On the stenciled layer, apply a line of On Point Glue all around the perimeter. Sprinkle with Twinkle Glitter. 
  11. On the card base, apply a line of Tear It Tape across the bottom of the card and across the right side.
  12. Sprinkle with Twinkle Glitter. 
  13. Apply a line of On Point Glue around the edge of the die cut sentiment and apply Twinkle Glitter.
  14. Glue all layers together. 
Print Project

Also uses these supplies:

  • DP100 Detail White Embossing Powder
  • My Colors Cardstock by My Mind's Eye (Evergreen)
  • MEDIA Acrylic by DecoArt® (Cadmium Red Hue)
  • On Point Glue by Imagine Crafts
  • Tear It Tape by Imagine Crafts
  • Craft Mat
  • Scotch® ATG Gun

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project