Happy Easter Cherry Blossoms by Laura Drahozal
Cut the base card stock 8 1/2" by 5 1/2" and fold on the side.
Tape the Happy Easter Stencil over blue card stock with removable tape. Use a tape strip all the way across the top of the Easter stencil that will act as a hinge later. Then tape both of the sides and bottom.
Use the palette knife to remove the White Glossy Embossing Paste from the container and place on the paste spreader.
Place a strip of paste on the spreader that is as wide as the Happy Easter image.
Set the paste spreader on the stop of the stencil and pull it towards you, maintaining contact with the stencil, and filling in all the wells.
Carefully remove the tape from the bottom and sides of the stencil.
Using the top tape as a hinge, lift the bottom of the stencil carefully up and then away from the project.
While the paste is still wet, sprinkle with Crystal Glitter and let dry.
Repeat steps 2-6 using the Cherry Blossoms Stencil and the Regular Embossing Paste.
Let dry completely.
Color the Cherry Blossoms Stencils image with the Copic Markers.
Replace the Cherry Blossoms Stencil and tap with the Versamarker ink pad.
Remove the stencil.
Cover the image with the Deep Impressions Embossing Powder and heat,
Cut the Cherry Blossoms image near the bottom and separate, adhering it to the white card stock background.
Assemble the image.
Also uses these supplies:
Stampendous: GX220U Multi Ultra Fine Crystal Glitter
VM001 VersaMark™ Watermark Ink Pad by Tsukineko®
FREG020 Deep Impressions Clear Embossing Powder
Dreamweaver: DWLM234 Happy Easter Stencil
DWLG644 Cherry Blossoms Stencil
DWDEP Dreamweaver Regular Embossing Paste
DWDGWP Glossy WhiteEmbossing Paste
DWLM2010 Paste Spreader
DWDPK Palette Knife
Plus: Cardstock by Bazzill Basics Paper®
Copic® Markers (E35, Y19, R20, R43)
Scotch® 1/2" Adhesive Tape by 3M®
1/2" Removable Tape by 3M®
Embossing Heat Tool
If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.Submit A Project