Peacock Stencil MetallicFX by Dreamweaver Stencils

INSTRUCTIONS
  1. Fold a 4-1/4" X 5-1/2" panel of blue cardstock in half to form card base with fold on the left.
  2. Adhere a 4" X 5" panel of copper metallic cardstock to card front in the center.
  3. On a 3-1/2" X 5" panel of white cardstock paste the peacock in glossy black paste.
  4. Clean the stencil and allow the paste to dry.
  5. Replace the clean, dry stencil over the design.
  6. Using a sponge dauber, cover the peacock image with glue from the Palette Glue Pad.
  7. Apply MetallicFX to the image using a small stencil brush.
  8. Gently heat the image to set the adhesive.
  9. Brush off any excess mica powder before removing stencil.
  10. Remove stencil and adhere image to a 3-5/8" X 5-1/8" panel of black cardstock.
  11. Adhere layered image panels to card front as shown.
Print Project

Also uses these supplies:

Blue, Copper, Black, and White Cardstock
Removable tape
Tray with water and soft brush for clean up
ZipDry™ Paper Glue by Beacon Adhesives®
 

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project