House-Mouse® Handstand by Louise Healy

INSTRUCTIONS
 
  1. Fold a 5-1/2" x 8-1/2" piece of green cardstock in half to form an A2 card.
  2. Place the Opto Checkerboard stencil on the big platform of the die cut machine, spritz a 4-1/4" x 5-1/2" piece of white cardstock with a fine mist of water and lay the paper on the stencil. Place the rubber embossing mat on the paper, then 2 new cutting plates, and run the stack through the machine.
  3. Remove the stencil, swipe the New Sprout ink pad over the embossed image until you get the amount of color you want, trim to right along the design on all sides.
  4. Cut a 4" x 5-1/4" piece of brown cardstock and adhere the embossed Opto Checkerboard to the mat then to the card front.
  5. Stamp the saying on a 1/2" x 1-3/8" piece of white cardstock, swipe the edges with the New Sprout ink, mat on a 5/8" x 1-1/2" piece of brown.
  6. Stamp the mouse image on a 2-3/8" x 3" piece of white, and color with Copic markers.
  7. Cut a  2-1/2" x 3-1/8" piece of brown cardstock and adhere the mouse image to the mat.
  8. Use Glue Dots to attach a brown ribbon across the card about an inch up from the bottom.
  9. Use foam tape to attach the mouse image, and then adhere the saying to the corner of the mouse.
  10. Thread white floss through two green buttons and attach them to either side of the mouse along the ribbon using mini glue dots.
Print Project

Also uses these supplies:

Cardstock by My Mind's Eye®
Copic® Markers (W0, W2, W4, E42, E93, B60, YG03)
Memento™ New Sprout Ink by Tsukineko®
Rubber Embossing Mat
Die Cut Machine
Foam Tape
Buttons
Mini Glue Dots
Ribbon by May Arts®
ZipDry™ Paper Glue by Beacon Adhesives®

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project