Snowman Peeking Metal Stencil by Alison Heikkila
- Tape the Snowman Peeking Stencil to a piece of Mixed Media Paper, but only at the top, to create a hinge.
- Using VersaMark Ink and a sponge dauber, apply the ink to the eyes and mouth of the stencil. I recommend using either the Picasso tool or a piece of tape to tape off the nose, so that you don't ink that area accidentally.
- Lift the stencil up using the tape hinge (keep it attached) and sprinkle Detail Black Embossing Powder on to the inked areas. Heat set.
- Replace the stencil and ink the nose with VersaMark. Use the Picasso tool or tape to avoid inking other areas.
- Lift the stencil and sprinkle Carnelian Embossing Powder on. Heat set.
- Replace the stencil and apply VersaMark Ink to the brim of the hat.
- Lift the stencil and sprinkle Sparkle Puff Embossing Powder on and heat set.
- Replace the stencil and ink the largest stripe of the hat.
- Sprinkle with Winter Green Embossing Powder and heat set.
- Ink the middle stripe of the hat with VersaMark ink. Using tape to block off this area may be the easiest.
- Sprinkle Aqua Tinsel Embossing Powder and heat set.
- Ink the top stripe of the hat.
- Lift the stencil and sprinkle Winter Green again. Heat set.
- Apply ink to the puff of the hat.
- Sprinkle on Sparkle Puff and heat set.
- Remove the stencil and trim the image down to 3-1/2" x 5."
- Create the card base out of Caribbean Sea cardstock, cut to 6-1/2" x 10."
- Create a mat out of Bo Bunny Turquoise Double Dot.
- Attach a piece of ribbon to the bottom of the mat, and secure on the back.
- Attach the mat and the stenciled image to the card base.
- Apply a line of On Point Glue around the edge of the stenciled image and sprinkle on Shaved Ice.
Also uses these supplies:
- DP111 Detail Black Embossing Powder
- EP222 Carnelian Embossing Powder
- EP525 Sparkle Puff Embossing Powder
- EP161 Winter Green Embossing Powder
- EP180 Aqua Tinsel Embossing Powder
- My Colors Cardstock by My Mind's Eye (Caribbean Sea)
- Turquoise Double Dot Patterned Paper by BoBunny
- 3/8" Black with White Stitching Ribbon by Creative Impressions
- Sponge Dauber
- On Point Glue By Imagine Crafts
- Scotch® ATG Gun