Wreath Metal Stencil Green by Janelle Stollfus

INSTRUCTIONS
  1. Make a tent card from 8-1/2 x 5-1/2 inch Parrot cardstock.
  2. Trim Double-Sided Mounting paper to the size of the stencil.
  3. Remove liner and place on white cardstock, rub down so it is secure on the cardstock.
  4. Trace the berries through the stencil onto extra cardstock and use eyelet tool to make a stencil.
  5. Remove top liner off of white cardstock and place down on a flat surface
  6. Tap Watermark Ink onto the back of Wreath stencil covering completely. Align on top of the sticky panel of white cardstock and tape down.
  7. Align the eyelet stencil over Wreath and tape down.
  8. Add Red Micro Glitter in certain spots, tap off excess and repeat with Rose Jewel Glitter.
  9. Take of eyelet stencil and mask around the ribbon of the Wreath stencil and repeat Red and Rose glitter.
  10. Take off the mask around the ribbon and finish with Lime Micro Glitter.
  11. Remove mask and Wreath stencil and sprinkle Sunflower Micro Glitter sparingly around exposed sticky panel. 
  12. Sprinkle Multi Ultra Fine Crystal Glitter over the entire sticky paper and rub in, remove excess and trim white cardstock away.
  13. Glue to Brick cardstock and then onto Parrot card base.
Print Project

Also uses these supplies:

  • MG07 Sunflower Micro Glitter
  • MG08 Lime Micro Glitter
  • MG011 Red Micro Glitter
  • GX220U Multi Ultra Fine Crystal Glitter
  • GM252U Rose Jewel Ultra Fine Glitter
  • My Colors Cardstock by My Mind's Eye (Parrot)
  • Cardstock by Bazzill Basics Paper (Brick)
  • Eyelet Tool and Hammer
  • ZipDry™ Paper Glue by Beacon Adhesives
  • 1/2" Removable Tape by 3M®

If you've use this product in a project of yours, we'd love to see it! You can submit your step-by-step instructions and supplies used by clicking below.

Submit A Project